Page 1 of 1

Segmentation fault

Posted: Tue Apr 05, 2011 11:24 pm
by jvelev
Hello,

I have been having problems running VASP version greater than 5.2.2. I compiled version 5.2.11 with PGI with the same makefile I use for the 5.2.2 version. It compiles fine but when I try to run gives a segmentation fault somewhere midway through the calculation (actually right after the first non-self-consistent steps)

[c2818:12643] *** Process received signal ***
[c2818:12644] *** Process received signal ***
[c2818:12644] Signal: Segmentation fault (11)
[c2818:12644] Signal code: Address not mapped (1)
[c2818:12644] Failing at address: 0x70
[c2818:12646] *** Process received signal ***
[c2818:12646] Signal: Segmentation fault (11)
[c2818:12646] Signal code: Address not mapped (1)
[c2818:12646] Failing at address: 0x70
[c2818:12643] Signal: Segmentation fault (11)
[c2818:12643] Signal code: Address not mapped (1)
[c2818:12643] Failing at address: 0x70
[c2818:12645] *** Process received signal ***
[c2818:12645] Signal: Segmentation fault (11)
[c2818:12645] Signal code: Address not mapped (1)
[c2818:12645] Failing at address: 0x70
[c2818:12646] *** End of error message ***
[c2818:12643] *** End of error message ***
[c2818:12644] *** End of error message ***
[c2818:12645] *** End of error message ***
----------------------------------------------------------------------mpirun noticed that process rank 3 with PID 12646 on node c2818.local exited on signal 11 (Segmentation fault).
----------------------------------------------------------------------

Anyone having a problem like that?
Also where can I get makefiles for Intel and GFortran for Linux? The ones distributed with the source are obsolete (and there isn't one for Gfortran).

Segmentation fault

Posted: Tue May 31, 2011 5:37 pm
by admin
1) please always use the makefiles which are delivered with the respective release of the code.
2) for the intel compiler please use the makefile.linux_ifc_P4 (please replace ifc by ifort)