How to compile VASP in parallel mode in IBM-POWER5 (OS:-AIX)
Posted: Thu Aug 09, 2007 10:15 am
Dear all,
We have a Power 5 Machine with the following specs.
Processor: total 6 (Dual Core)
Cpu : POWER5 (gs)
Clock : 2.2 GHz
RAM : 48 GB
OS : AIX
SMP Machine.
We have succesfully compiled VASP with the makefile, "makefile.rs6000" in serial mode. In this makefile there is no Parallel section. So how to compile VASP in parallel mode?
When we run a job in serial mode we guess it is going to a single processor, what we should do so that it will utilize all the processors.
With Regards,
Saurabh & Shubhodeep B)
We have a Power 5 Machine with the following specs.
Processor: total 6 (Dual Core)
Cpu : POWER5 (gs)
Clock : 2.2 GHz
RAM : 48 GB
OS : AIX
SMP Machine.
We have succesfully compiled VASP with the makefile, "makefile.rs6000" in serial mode. In this makefile there is no Parallel section. So how to compile VASP in parallel mode?
When we run a job in serial mode we guess it is going to a single processor, what we should do so that it will utilize all the processors.
With Regards,
Saurabh & Shubhodeep B)