My Community

Dear colleagues,

I would like to use VTST in VASP, and generate image files between initial and final structures with the code nebmake.pl. VTST was installed, and all the tests were passed. I copied the scripts nebmake.pl and vast.pm to the folder, and type: nebmake.pl CONTCAR1 CONTCAR2 5. However, nothing happened, and the command nebmake.pl can't be recognized. Can someone tell me how to run nebmake.pl?

Thanks!
Tina

VTST is not software developed by the VASP Software GmbH, so unfortunately we cannot give you any guidance on how to use it. Perhaps some other users have experience with this package?

I think the command you used is okay, just try ./nebmake.pl POSCAR00 POSCAR05 4 then it should work fine, rename your CONTCAR to POSCAR