My Community

Hello,

From the hands-on session (provided on the VASP homepage), there
an example in Handson Session 2, directory "2_8_fccNi_dos".

It calculates the DOS of a Ni bulk, with this INCAR file: The DOSCAR is explained at
http://cms.mpi.univie.ac.at/vasp/vasp/node71.html

The DOSCAR file has roughly three sections:
1. Header (I understand that)
2. DOS & Intergrated DOS, with 5 columns (I understand that too).
3. The so-called "lm- and site-projected DOS", with 19 columns (I don't understand this one).

Can somebody explain what these 19 columns per line represent?
I tried several possibilities, but neither counted up to 19 columns....

If I remove the ISPIN and MAGMOM line in the INCAR file, then
that corresponding part 3 of the DOSCAR file has 10 columns,
yet another misterious number of columns.

I would appreciate very much if someone could explain to me what
these columns in the DOSCAR file are about.

I used the Ni-fcc handson example, as it might be a well known example
among the vasp users. I hope through this example, to understand
better the general layout of the DOSCAR file.


Thanks so much,
Rob.

As far I understand the 10 columns are

E followed by lm-DOS for each l going from -m,...,0,...,+m with the lm-ordering: s, p_y, p_z, p_x, d_xy, d_yz, d_z2-r2, d_xz, d_x2-y2. If spin-polarized calculations are performed (ISPIN = 2), the spin-down component of each respective partial DOS will be printed after the spin-up component, so the ordering will be: s(up), s(down), p_y(up), p_y(down) etc. and therefore you will have 19 columns. Please correct me if I'm wrong.

Best regards
Dan Fors