how to get vasp utilities: drawdos, toband, band etc.?
thanks!
vasp utilities
Moderators: Global Moderator, Moderator
-
- Newbie
- Posts: 1
- Joined: Fri Jun 11, 2010 9:55 pm
- License Nr.: Nr 5-608
- Location: University of Calgary, Canada
vasp utilities
Last edited by bzhou on Fri Jul 02, 2010 11:31 pm, edited 1 time in total.
-
- Administrator
- Posts: 2921
- Joined: Tue Aug 03, 2004 8:18 am
- License Nr.: 458
vasp utilities
these utilities are not needed in all newer vasp versions (since vasp.4.5) any longer, because these routines have been incorporated into the code
Last edited by admin on Tue Jul 06, 2010 2:59 pm, edited 1 time in total.
vasp utilities
so this section of the manual is useless:
http://cms.mpi.univie.ac.at/vasp/vasp/A ... tions.html
<span class='smallblacktext'>[ Edited Fri Feb 03 2012, 05:38PM ]</span>
http://cms.mpi.univie.ac.at/vasp/vasp/A ... tions.html
<span class='smallblacktext'>[ Edited Fri Feb 03 2012, 05:38PM ]</span>
Last edited by ziulfer on Fri Feb 03, 2012 5:37 pm, edited 1 time in total.
-
- Administrator
- Posts: 2921
- Joined: Tue Aug 03, 2004 8:18 am
- License Nr.: 458
vasp utilities
not for colleagues using VERY OLD vasp-versions
Last edited by admin on Mon Feb 27, 2012 12:15 pm, edited 1 time in total.
-
- Newbie
- Posts: 29
- Joined: Mon Jun 19, 2006 7:03 am
- License Nr.: 853
- Location: FAMU
vasp utilities
I am using VASP at a computing center, version 4.6. by invoking a module load command. Explicitly,
module load vasp/4.6
I suspect to run drawdos, one must set the path to where the drawdos executable is (am I right?). But I do not have access to the vasp directories.
I would appreciate if you would write down the command with the path.
module load vasp/4.6
I suspect to run drawdos, one must set the path to where the drawdos executable is (am I right?). But I do not have access to the vasp directories.
I would appreciate if you would write down the command with the path.
Last edited by vasp on Sat Mar 16, 2013 11:52 am, edited 1 time in total.